Terms Used in Direct Method of Levelling

The following terms are used in direct method of levelling:
(i) Plane of Collimation: It is the reduced level of plane of sight with respect to the datum selected. It is also known as height of instrument. It should not be confused with the height of telescope from the ground where the instrument is set.
(ii) Back Sight (BS): It is the sight taken on a level staff held on the point of known elevation with an intension of determining the plane of collimation. It is always the first reading after the instrument is set in a place. It is also known as plus sight, since this reading is to be added to RL of the point (Benchmark or change point) to get plane of collimation.
(iii) Intermediate Sight (IS): Sights taken on staff after back sight (first sight) and before the last sight (fore sight) are known as intermediate sights. The intension of taking these readings is to find the reduced levels of the points where staff is held. These sights are known as minus sights since the IS reading is to be subtracted from plane of collimation to get RL of the point where staff is held.
(iv) Fore Sight (FS): This is the last reading taken from the instrument station before shifting it or just before ending the work. This is also a minus sight.
(v) Change Point (CP): This is also known as turning point (TP). This is a point on which both fore sights and back sights are taken. After taking fore sight on this point instrument is set at some other convenient point and back sight is taken on the staff held at the same point. The two readings help in establishing the new plane of collimation with respect to the earlier datum. Since there is time gap between taking the two sights on the change point, it is advisable to select change point on a well defined point.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top